A Review on Numerical Simulation and Comparison of Carbide and HSS Tool Wear Rate while Drilling with Difficult To Cut Super Alloy Titanium Based on Archard Model |
| ( Vol-5,Issue-9,September 2018 ) OPEN ACCESS |
| Author(s): |
Rahul D. Shelke, Shaikh Ateshamoddin Rafiuddin |
| Keywords: |
|
Finite Element Analysis, Titanium Drilling, ArchardËŠs Model, Wear Rate, Carbide and HSS Tool. |
| Abstract: |
|
A Carbide and HSS tool wear rate simulation using Archardˊs wear model is proposed, finite element modelling is done using commercial finite element software ABAQUS/explicit. ABAQUS interface was used to simulate the contact pressure. For measuring wear depth of tool’s drilling operation is performed experimentally then wear depth is measured on profilprojecter. Comparing the wear rate, based on Archad model. |
 DOI:
|
| Paper Statistics: |
|
| Cite this Article: |
| Click here to get all Styles of Citation using DOI of the article. |
- Track Your Paper
- editor.ijaers@gmail.com
- ISSN : 2349-6495(P) | 2456-1908(O)
Advanced Engineering Research and Science